Edge Lighting PSB-400W-24VDC-RGB, 400 Watt 24 Volt DC Power Supply User Manual
Installation instructions for, General information important safety instructions, Save these instructions

Installation Instructions for
400 Watt 24 Volt DC RGB DMX
LED Power Supply
904-PSB-400W-24VDC-02
SAVE THESE INSTRUCTIONS!
- Do not install this power supply in a wet location.
- To reduce the risk of the system overheating and possibly
causing a fire, make sure all the connections are tight.
- Do not install *LED fixture closer than three inches or as
specified in the *LED fixture installation instructions to
curtains or similarly combustible materials. Keep insulation
at least 3" away from the enclosure.
- Turn the electrical power off before modifying the lighting
system in any way.
- The system is "ETL" listed for USA and Canada only when
all the products used are supplied by Edge Lighting.
* See LED fixture installation instructions for proper
placement.
- RISK OF FIRE: This product must be installed by a
qualified electrician. Turn the power to the electrical box off
during installation. Read the "Important Safety Instructions "
before installation.
- This product is not suitable for wet locations. It is approved
for the use at any height above the finished floor.
- A typical installation is shown. Specific installation must be
in accordance with the local electrical codes.
- TO REDUCE RISK OF FIRE, it is important to wire the
power supply for the system as described in this
installation instruction.
- Load the power supply to MAXIMUM 400 Watts.
- Use CDP color dial or CTP color touch screen controller with
RGB LED soft strip.
GENERAL INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
1
400W, 24VAC LOW VOLTAGE WIRE SIZE CHART
VOLTAGE
DROP
UP TO 12FT
3%
13FT-20FT
VOLTAGE AT END
OF THE WIRE
12 AWG
23.8 VAC
21FT-30FT
31FT-47FT
10 AWG
8 AWG
6 AWG
WIRE LENGTH
IN FT
48FT-73FT
4 AWG
WIRE SIZE
23.8 VAC
23.8 VAC
23.8 VAC
23.8 VAC
100W, 24VAC LOW VOLTAGE WIRE SIZE CHART (PER RUN)
VOLTAGE
DROP
UP TO 31FT
3%
32FT-49FT
VOLTAGE AT END
OF THE WIRE
14 AWG
23.3 VAC
50FT-81FT 82FT-124FT
12 AWG
10 AWG
8 AWG
WIRE LENGTH
IN FT
WIRE SIZE
23.3 VAC
23.3 VAC
23.3 VAC
WARNING: This power supply is equipped with a cooling fan. Do not run the power supply in a dusty environment.
All drywall finish and sanding must be done prior to using the power supply. Dust particles may stop the fan from
working & eventually destroy the power supply.
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2014 Edge Lighting. All Rights Reserved.