Edge Lighting Cirrus Channel, Wall Grazer User Manual
Connecting the channel, Mounting channel for proper lighting distribution, Important information

1: Mount the crossbar to the Junction box holes with the two
#8-32 screws provided.
#8-32 SCREW
CROSSBAR
JUNCTION BOX
1
NOTE:
C-1RE-JBOX.
Omit this section and follow steps on Page 3 when using
Installation Instructions for Cirrus Channel, Wall Grazer, 24VDC
904-CC-WG-02
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2013 Edge Lighting. All Rights Reserved.
CC-WG-7WDC-_
1
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
- Per NEC Article 410.16(A)(1)(3) & 410.16(C)(5). Approved
for Closet Storage Areas.
IMPORTANT INFORMATION
TEXTURED W
ALL
STUD
CEILING
LIGHT
BEAMS
TEXTURED W
ALL ON A
11°
STUD
CEILING
LIGHT
BEAMS
B
1: Choose one of the two options to install the channel to
properly graze the textured wall.
Option B: Mount the channel 3" to 6" away from the
straight textured wall.
Option C: Mount the channel next to the textured wall
that is installed at an 11° angle.
C
JOINER BRACKET
CHANNEL
1
LENS
Connecting the Channel
JOINER CHANNEL
MALE
CONNECTOR
FEMALE
CONNECTOR
CHANNEL
FRONT
VIEW
TOP OF CHANNEL
A
D
Mounting Channel for proper
Lighting Distribution
1: Lift a section of the lens at the end of the channels where
the connectors are visible. Slide the channel over the joiner
bracket make sure that the male & female connectors mate
properly.
2: Push the lens back into the channel.
NOTE:
piece (120" or less).
Omit this section if the channel is made out of a single
NOTE:
Prior to installation, multi-sectional Cirrus Channel should
be connected together for marking proper measurements.
NOTE:
It is recommended more than one person to assist in this
installation.
NOTE:
(C-1RE-BOX), continue to "Install the Channel using the Junction
Box (C-1RE-JBOX)" on page 3.
When using Edge Lighting Slim Profile Junction Box
Install Channel on Standard Junction Box W/Plaster Ring or Octagon Box