Amico Falcon Combo Arm - Manual (Page 24)

24 Amico Accessories Inc.
MRS Rail Cable Management
NOTE: A MRS cable guide is provided to facilitate routing of cables
along the Rails.
1. Depending on where your electrical outlet is located, guide the
cables from the FIT station into the side of the channel leading to
the outlet. (Figure 1)
2. Guide the MRS rail cable cover into the channel over the cable.
Ensuring no cable is pinched between the rail and the cover.
Safely trim off any excess MRS cover after installation.
AHM Arm Cable Management
NOTE: FIT cable guide is provided to facilitate routing of cables along the bottom of the arm.
NOTE: Longer cable guides are provided for arms with extensions. Guides also snap into grooves on the bottom of
extension arms.
1. After installation of All in one/CPU, take the power cables and press them between the openings of the cable
cover (Figure 1).
2. Ensure that there are at least 2” (5.08cm) of slack cabling hanging free at the front end of the AHM.
SECTION 3: Device Installation
(Figure 3)
Direction to slide
MRS Rail Cover
(Figure 1)
Cable Cover
Cable Guide Cable
Guide
Edge
Bottom view of the
AHM Arm
(Figure 2)
AHM arm with cables
inserted