Swivel post cable management – Amico Falcon Combo Arm User Manual
Page 20
20 Amico Accessories Inc.
Cable Management For Independently Mounted CPU
Keyboard Tray Cable Management
WARNING
Do not bunch cables together on one tie. It may destroy the cable clips.
Keep your cables in separate cable clips. Two cable clips are provided for use.
NOTE:
Ensure keyboard and mouse are both properly positioned as per the manual
before beginning cable management procedures.
1. Take the mouse and keyboard cables, simply push the cable gently into the guide-clip
until it sits inside it’s receptacle. (Figure 1) OR, remove the screw of the cable guide using
a philips head screwdriver, through both holes on the cable guide. Push the Keyboard
tray cable guide into the cable, and then re-align and re-attach the screw with a Philips
screw driver.
2. Ensure the cable can still be moved forward and backwards in the guide.
(Figure 1)
Swivel Post Cable Management
WARNING
Do not bunch cables together on one cable guide-channel. Use separate channel for each cable
1. There are 2 FIT cable guide-channels in the Swivel post, which is covered by the Swivel Post Cable Cover.
2. Pop outthe Swivel Post Cable Cover, your monitor cables and place the cable gently into the guide-channels
(Figure 1, 2).
3. Push-fit the Swivel Post Cable Cover, so that the cables pass through the Bottom 2-holes and come out from the
top 2 holes (Figure 3).
4. Ensure the cables can still be moved up and down through the guide-channels.
(Figure 1)
Cable guide
channel
(Figure 3)
Swivel Post
Cable Cover
(Figure 2)
Cable laid
SECTION 3: Device Installation