Amico Falcon Combo Arm - Manual (Page 15)

www.amico.com 15
CPU Mount
WARNING Ensure CPU is within weight and size rating of the CPU mount. If not, please contact Amico
Accessories at (1-877-264-2697).
WARNING Removal of lock nuts will require a new set for reinstallation. Please contact Amico Accessories for
spare parts at (1-877-264-2697)
WARNING The CPU mount can be mounted anywhere at any height on the rail. However, DO NOT mount
anywhere above a patient’s head.
WARNING Ensure rail is stable and properly installed before mounting FIT Station.
1. Determine a suitable location on your Hill-Rom rail for the CPU mount, making sure it isn’t above the patient’s
head.
2. Loosen the Heads of the Mounting Adapters by turning the wheels (Figure 1). Guide the head of the top GTA pin
on the upper Mounting Adapter into the opening of the rail. Ensure the flange on the GTA is properly aligned
with the rail. Slide the GTA up so that the head of the bottom GTA pin slides into the opening of the rail (Figure
2).
3. Position the CPU Mount to the desired height. Tighten the heads by turning the wheel in the opposition
direction from before. (Figure 3).
Wheel
(Figure 1)
SECTION 2: Installation on Rail Systems
(Figure 3)
GTA
Hill-Rom
Rail
Opening of
the rail
(Figure 2)
Backside of the GTA
Flange
Head of
the top
GTA pin
Head of the
bottom
GTA pin