Lift lock, Rotate to transport alignment, Lift lock rotate to transport alignment – Great Plains YP825AR Operator Manual User Manual
Page 37: Table of contents index operating instructions 33, Table of contents index, Figure 29 rotate to transport
Great Plains Manufacturing, Inc.
Operating Instructions
33
2014-06-17
401-923M
Lift Lock
Refer to Figure 28
13. Set LIFT LOCK switch ( , gray) to ON.
Move tractor remote handle for the lift/marker circuit
to Extend to engage the lift lock pins.
Visually check that the pins are over the plates.
14. Set the tractor remote to Neutral.
Set the LIFT LOCK switch to OFF.
Note: At this step, it is now safe to operate the marker
shut-off valve. It is generally more convenient to
complete the transport fold first, so marker shut-off
is deferred to step 20.
Note: It is possible to perform this step before the tongue
is extended. If access to planting components is
required, such as openers, engage the lift locks to
ensure it is safe to work under the raised planter.
Rotate to Transport Alignment
Refer to Figure 29
15. Set ROTATE switch ( , blue) to ON.
Move tractor remote handle for the rotate/telescope
circuit to Extend to rotate the frame to transport
position.
16. When rotation completes:
Set the tractor remote to Neutral.
Set the ROTATE switch to OFF.
Note: If the frame does not rotate, verify full lift.
A limit switch prevents rotation if the frame is not
fully raised.
Also verify that the tongue is fully extended. A limit
switch prevents rotation if the tongue is not fully
extended.
Figure 28
Fold: Lift Locks Engage
34705
tbd
HALF
OFF
OFF
OFF
OFF
OFF
FULL
ON
ON
ON
ON
LIFT
TELESCOPE ROTATE
FRAME
LIFT
7
7
Figure 29
Rotate to Transport
34705
34802
34798
34797
HALF
OFF
OFF
OFF
OFF
OFF
FULL
ON
ON
ON
ON
LIFT
TELESCOPE ROTATE
FRAME
LOCK
LIFT
LOCK
POWER
ON
OFF
5
5