Pivot unlock, Rotate to field alignment, Pivot unlock rotate to field alignment – Great Plains YP825AR Operator Manual User Manual
Page 32: Table of contents index, Figure 19 unfold: frame unlock, Figure 20 rotate out of transport
28
YP825AR
Great Plains Manufacturing, Inc.
401-923M
2014-06-17
Pivot Unlock
3.
Clear all persons from the vicinity of the planter.
Crushing, Overhead and Pinch/Shear Hazards:
Clear all persons from the area. During unfold there are
multiple locations with risk of severe or fatal crush, pinch,
shear and head injuries.
4.
Put tractor in Park or set parking brake
a
.
Refer to Figure 19
5.
Set FRAME LOCK switch ( , yellow) to ON.
Verify the other four are OFF.
Verify/set all frame control POWER switch (red) ON.
Verify POWER LED illuminated.
6.
Start the tractor. Hydraulic remotes must be active
for unfold.
7.
Move tractor remote handle for the rotate/telescope
circuit to Retract to unlock the frame.
Observe the vertical cylinder
at the forward end of
the opener frame. When the rod is fully retracted,
set the tractor remote to Neutral.
Set FRAME LOCK switch
to OFF.
Rotate to Field Alignment
Set ROTATE switch ( , blue) to ON.
Move tractor remote handle for the rotate/telescope
circuit to Retract to rotate the frame from transport to
field alignment.
Set the tractor remote to Neutral.
Set the ROTATE switch to OFF.
a. If the planter has the optional telescoping axle, the planter must move during tongue telescope and contraction (page 29 and page 32).
If the planter does not have a telescoping axle, either/both planter or tractor may move during telescope.
Figure 19
Unfold: Frame Unlock
34705
34797
HALF
OFF
OFF
OFF
OFF
OFF
FULL
ON
ON
ON
ON
LIFT
TELESCOPE ROTATE
FRAME
LOCK
LIFT
LOCK
POWER
ON
OFF
6
8
6
6
Figure 20
Rotate Out of Transport
34705
34798
HALF
OFF
OFF
OFF
OFF
OFF
FULL
ON
ON
ON
ON
LIFT
TELESCOPE ROTATE
FRAME
LOCK
LIFT
LOCK
POWER
ON
OFF
5
5