Great Plains CDA600 Operator Manual - Manual (Page 79)

77 Centurion CDA600
270-600M-ENG
2013-06-14
5.11 Unloading Materials
Unloading materials has the same risks
as loading material. Review the advice on
page 40. Take the same materials safety
precautions as for loading.
1. Position drill on a clear flat surface. Put
tractor in Park.
2. Place a suitable receptacle to catch
seed under the rear hose.
3. Move the calibration diverter to redirect
the flow of seed to the hose at the rear
of the machine.
4. Open the meter door.
5. With the fan running, engage the yellow
button at the front of the drill. This will
empty the hopper through the hose at
the rear of the machine.
6. Shut down tractor.
7. Open meter box and remove roller.
Clean out meter.
8. Wipe down doors and bottom of meter.
9. Replace roller, close meter box and
meter door.
In instances where it is not possible to
operate the air system to empty the hopper
a chute is installed on the side of the hopper.
5. Servicing and Maintenance
Figure 60. Calibration diverter
Figure 61. Front seedflow switch
Figure 62. Hopper emptying chute.