Great Plains CDA600 Operator Manual - Manual (Page 55)

53 Centurion CDA600
270-600M-ENG
2013-06-14
4. Adjustment / Operation
4.18.3 Work Screen (2/2)
1. This button switches the metering
function on and off. With the drill function
switched off the display will show ALL
METERING STOPPED at the top of the
screen. If the drill function is switched
on, the drill is lowered to work position
and the computer receives a speed
signal, the computer will start the control
process.
2. Boutmarker mode: Pressing this button
cycles through the boutmarker modes.
These are (in order):
• Alternating markers, starting with
right hand marker.
• Alternating markers, starting with
left hand marker.
• Left hand marker only
• Right hand marker only
• Both markers working.
• No markers working.
3. This button switches the display to the
home screen.
4. This symbol shows the current working
mode.
Figure 35. Work Screen 2
5. Half width shut off - Left: Only the right
hand outlets will continue seeding.
6. Half width shut off - Right: Only the left
hand outlets will continue seeding.
7. This button increases the sensitivity of
seedflow sensors.
8. This button decreases sensitivity of
seedflow sensors.
9. This button allows the user to switch
between screens. The second screen
(2/2) defaults back to the first screen
(1/2) after 12 seconds.