04 removing skid, 05 filling power supply coolant – Tweco 3000 Merlin User Manual
Page 20

INSTALLATION
3-2
Manual 0-2532
3.04 Removing Skid
The Power Supply is mounted on the skid with two brack-
ets. Remove the Power Supply from the skid per the
following procedure:
1. Remove the six bolts connecting the brackets to the
base of the Power Supply.
A-00953
Three Bolts
(Each Side)
Shipping Brackets
Shipping Pallet
Figure 3-1 Skid Removal From Power Supply
2. Roll the Power Supply off the skid backwards (rear
wheels first).
3.05 Filling Power Supply Coolant
The ambient temperature of the environment where the
Power Supply will be located determines the coolant to
be used. The Standard Torch Coolant supplied with the
system can be used in ambient temperatures down to
10° F (-12° C).
Optional Super Torch Coolant should be used in areas
where the ambient temperature drops down to -27° F (-
33° C).
CAUTION
Use only Thermal Arc Torch Coolant. Use of
any other coolant can result in torch damage,
insufficient thermal protection, and/or pilot arc
interference.
1. Locate the coolant deionizer bag and remove from
the plastic shipping bag.
2. Remove the coolant filler cap from the reservoir
at the top rear of the Power Supply.
3. Place the deionizer bag into the basket in the cool-
ant reservoir.
Coolant Reservoir
Filler Cap
Deionizer
Bag
Basket
Coolant Level Indicator
A-00872
Figure 3-2 Coolant Reservoir