SoundOff Signal LED Compact License Plate Light (10-30v) - Manual

ECVLPBLED30 8.08
LICENSE PLATE LIGHT 10-30Vdc
ECVLPBLED30
WARRANTY
Except for our limited warranty, available on our website at www.soundoffsignal.com, a hard copy of which can be obtained from SoundOff Signal upon request, all other guarantees or warranties including the
implied warranty of merchantability and the implied warranty of fitness for any particular purpose are void and of no effect, unless specifically agreed to in writing by SoundOff Signal.
! WARNING
This product contains high intensity LED
devices. To prevent eye damage, DO NOT
stare into light beam at close range.
MOUNTING INSTRUCTIONS
A. If screw holes do not exist use housing to
locate pilot holes for #8 screws.
B. With screw holes located and drilled place
gasket in position and drill hole for wire pass
through. This hole must not have sharp
edges that could damage wires.
C. Install light in housing by sliding into place in
grooves in interior as shown. DOT SAE
GRAPHICS MUST BE TOWARD REAR OF
HOUSING AS SHOWN IN THE DETAIL.
D. Make electrical connections.
E. Make electrical connections with gasket in
proper position.
F. Place light and housing assembly over
gasket and secure with screws. DO NOT
OVER TIGHTEN.
Electrical Connections
White Wire Ground
Black Wire +10-30Vdc
Gasket
IMPORTANT! DOT
SAE Graphic MUST be
to rear of housing for
proper function
Housing
#8 Screws