SoundOff Signal 350 Series Marker User Manual
Marker / clearance lights, Ecvmlt351(x)
ECVMLT351(x) 11.07
MARKER / CLEARANCE LIGHTS
ECVMLT351(x)
The 350 Series marker light (red or yellow)
is easily installed but because the light is
equipped with chassis ground (allowing for
single power wire installation) these
instructions must be followed closely.
WIRING INSTRUCTIONS
GROUND (-): Internal
RED WIRE (+): Connect to Power Source +12Vdc
1. Use light to establish screw locations and
approximate location of power wire exit.
Ensure there are no burrs that may chafe or
cut wire.
2. Push wire through foam gasket’s rear hole
and make a connection to +12Vdc.
3. Install light as shown. Note that the ground
side will be on the left side of the vehicle and
care must be taken to install spacer, O-rings,
washers and screws in the sequence shown
at right.
4. DO NOT OVERTIGHTEN SCREWS. This
may cause damage to the light or vehicle’s
surface.
PART NUMBERS
ECVMLT351Y - Marker, Yellow
ECVMLT351R - Marker, Red
WARRANTY
Except for our limited warranty, available on our website at www.soundoffsignal.com, a hard copy of which can be obtained from SoundOff Signal upon request, all other guarantees or warranties including the
implied warranty of merchantability and the implied warranty of fitness for any particular purpose are void and of no effect, unless specifically agreed to in writing by SoundOff Signal.
FLAT WASHERS
1-1/4” SCREWS
RUBBER O-RINGS
2 ON LEFT, 1 ON RIGHT
METAL SPACER
SERIES 350 MARKER /
CLEARANCE LIGHT
(ARROW POINTS TO LEFT SIDE)
FOAM GASKET
POWER WIRE