SoundOff Signal GHOST Spot Surface Mount User Manual
Warning, Ghost® spot light, single surface mount
1.800.338.7337 / www.soundoffsignal.com
IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact
Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800.338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
• DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to your vehicle
Owner’s Manual for the location of any air bag deployment zones.
• DO NOT connect this device to a strobe power supply. This product is self-contained and does not
require an external power supply.
EGHSTS2(xx) 07.14
Important Information:
OPERATION:
WIRE CONNECTIONS
1. Connect the GHOST BLACK wire to a
good, convenient ground.
2. Connect the GHOST RED and WHITE
wire to one side of a user supplied on/
off switch. Connect the other side of the
switch, through a 3Amp fuse, to a source
of +10-30Vdc. Both RED and WHITE
wires
MUST be connected to power.
NOTE: The GHOST is a factory sealed unit
that CANNOT be serviced in the field. Any
attempt to gain access to the GHOST unit
will most likely cause permanent damage
and void its warranty.
INSTALLATION:
Establish a position on the vehicle. Use
the gasket (provided) as a template
to
drill
½”
wire hole and pilot holes
for mounting screws. Note: pilot holes
are 4-7/8” on center.
Caution: Do not
stretch gasket as this may change
the required hole spacing.
WIRE HOOK-UP TABLE
WIRE COLOR:
CONNECT TO:
RED
+10-30Vdc
BLACK
Ground (-)
WHITE
+10-30Vdc
This product contains high
intensity LED devices. To prevent
eye damage, DO NOT stare into
light beam at close range.
WARNING
!
TECHNICAL
SPECIFICATIONS
Overall
Dimensions:
5.65”L x 1.06”H x
1.8”D
Input Voltage
Range:
10-30Vdc
Current
Consumption:
0.45A @ 12.8Vdc
0.23A @ 25.6Vdc
# of LEDs: 6 Generation 3 LEDs
Operating
Temperature:
-40º to +65º C
GHOST® SPOT LIGHT, SINGLE SURFACE MOUNT
EGHSTS2(x) - Black
EGHSTS2(x)C - Chrome
EGHSTS2(x)W - White