SoundOff Signal GHOST Spot Rock - Manual

1.800.338.7337 / www.soundoffsignal.com
IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800.338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to [email protected].
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
• Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances.
These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these
devices to ensure compliance.
• DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to your vehicle
Owner’s Manual for the location of any air bag deployment zones.
• DO NOT connect this device to a strobe power supply. This product is self-contained and does not
require an external power supply.
EGHSTS3(x) 07.14
Important Information:
INSTALLATION:
Establish a flat position on the vehicle.
D
rill a 9/32” hole in the center of
the mounting location. Attach bracket
as shown using external toothed
washer. Note: if 2 bolts are desired for
attachment, holes should be 2.5” apart.
Only one bolt is furnished.
Thread cable through center hole and
screw light to upper bracket. DO NOT
OVERTIGHTEN.
Place toothed washers over studs and
insert one stud in slot. Install outer
washers as shown and secure with
nuts.
Make electrical connections.
This product contains high
intensity LED devices. To prevent
eye damage, DO NOT stare into
light beam at close range.
WARNING !
TECHNICAL
SPECIFICATIONS
Overall
Dimensions:
4.77”L x 1.98”H x
1.62”D
Input Voltage
Range:
10-30Vdc
Current
Consumption:
0.45A @12.8Vdc
0.23A @ 25.6Vdc
# of LEDs: 6 Generation 3 LEDs
Operating
Temperature:
-40º to +65º C
WIRE HOOK-UP TABLE
WIRE COLOR: CONNECT TO:
RED +10-30Vdc
BLACK Ground (-)
WHITE +10-30Vdc
OPERATION:
1. With the Red and White wires attached
to +12Vdc and the black wire connected
to ground, the light will function.
IMPORTANT: DO NOT connect this device
to a strobe power supply.
NOTE: The GHOST is a factory sealed unit
that CANNOT be serviced in the field. Any
attempt to gain access to the GHOST unit
will most likely cause permanent damage
and void its warranty.
GHOST® SPOT LIGHT W/ ROCK BRACKET
EGHSTS3(x)