SoundOff Signal 4500 Series LED Beacon Class 1 - Manual

To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product please visit our website at www.soundoffsignal.com and select the “Warranty & Returns”
link along the left column of our home page. If you have questions regarding this product please contact Technical Services, Monday - Friday, 8 am to 5 pm at 1.800.338.7337, press #4 to
skip the automated message. Questions or comments that do not require immediate attention may be emailed to [email protected].
1.800.338.7337. / www.soundoffsignal.com / Thank you for trusting us with your safety!
SAE Class 1 LED Beacon
ELB45BM(z)+(x)(y) Magnet Mount
ELB45BC(z)Ø(x)(y) Flat/Pipe Mount
!
WARNING
This product contains high intensity LED devices.
To prevent eye damage, DO NOT stare into the
light beam at close range.
Please see reverse for
Technical Specifi cations
• Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances.
These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these
devices to ensure compliance.
• DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to your vehicle
Owner’s Manual for the location of any air bag deployment zones.
• DO NOT connect this device to a strobe power supply. This product is self-contained and does not
require an external power supply.
ELB45BM(z)+(x)(y) - ELB45BC(z)Ø(x)(y) 8.09
Important Information:
“REAR OF VEHICLE” ARROW
MAGNET MOUNT
ELB45BM(z)+(x)(y)
FLAT MOUNT / PIPE MOUNT
ELB45BC(z)Ø(x)(y)
Pattern Select
on Cigar Plug
INSTALLATION:
Magnet Mount
1) Install square metal plate with PEM
nut up using M3x10mm screws as
shown.
2) Carefully place beacon on steel top of
vehicle with “Rear of Vehicle” arrow
toward rear.
3) Route wire to 12V socket.
Flat Mount
1) Determine location where beacon is
to be installed and drill n 1/2” hole at
the center for cord exit.
2) Using the housing as a guide mark
the centers of hole positions in three
places (note “Rear of Vehicle” Arrow)
and drill appropriate pilot holes.
3) With wire through center of gasket
make electrical connections.
4) Ensure “Rear of Vehicle” Arrow is in
correct position and install 3 screws
being careful not to strip out pilot
holes. DO NOT OVERTIGHTEN.
Pipe Mount
Beacon may be installed on a vertical
pipe with 1” NPT thread.
1) Feed wires through pipe and make
electrical connections.
2) Screw base of beacon to pipe
(clockwise). Adjust pipe or beacon so
that “Rear of Vehicle” Arrow points to
the rear.
OPERATION:
Magnet Mount
1) Place beacon on roof of vehicle.
2) Route wire through window.
3) Plug into 12V socket.
4) Press arrow on cigar plug >1 sec but
<5 sec: pattern advances 1 step.
5) Press arrow for >5 sec pattern resets
to pattern #1.
Flat / Pipe Mount
1) Connect wires as shown below (note
that white wire is for momentary
ground (used for pattern selection)
and should be taped after pattern is
selected.
BEACON
RED BLACK
WHITE
MOMENT
ARY
GROUND
5 AMP FUSE
+12 Vdc