SoundOff Signal Predator2 WS Light Permanent Mount Headliner - Manual

EP2xWSA+(x) 4.08
! WARNING
This product contains high intensity LED
devices. To prevent eye damage, DO NOT
stare into light beam at close range.
WARNING : Warning devices are strictly
regulated and governed by Federal, State and
Municipal ordinances. These devices shall be
used ONLY on approved vehicles. It is the sole
responsibility of the user of these devices to
ensure compliance.
The PERMANENT MOUNT HEADLINER BRACKET
is designed for the Ford Crown Vic Police Interceptor.
Although it may fit other applications, the installer
assumes all responsibility for its installation.
Refer to the instructions included with the
PPRH1BKT for proper installation.
OPERATING INSTRUCTIONS
1. Plug the Predator II power cord into the vehicle
cigarette lighter plug.
Note: The Predator II protection fuse is located in
the nose of the cigarette lighter plug (not shown).
Unscrew metal retaining ring to expose fuse.
2. To activate the Predator II push the red button (#4)
on the left (driver's side) of the unit.
3. To deactivate the Predator II push and HOLD the
red button until unit turns off.
4. The Predator II can generate 33 different light
patterns (see table at right). To change light
patterns, momentarily push the red button, A,
while the unit is operating. Each push of the red
button will advance the Predator II to the next
pattern. When desired pattern is reached release
red button. That pattern will be stored in the
Predator II memory and will automatically come up
every time the unit is turned on.
Replacement Parts / Accessories
PPRH1BKT Permanent Mount Headliner Bracket
Optional Mounting Brackets
PPRDWBRKT Predator Windshield Bracket w/ Suction Cups
PZBKT248 Z Bracket for Mounting to Headliner - Permanent Mount
PPRDGMBRKT Predator Permanent Glass Mount Kit w/ Adhesive
PERMANENT MOUNT
HEADLINER BRACKET SYSTEM
ASSEMBLY INSTRUCTIONS
EP2SWSA+(x) [single] EP2DWSA+(x) [dual]