SoundOff Signal nForce WS Light (Dual) - Manual

To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product please visit our website at www.soundoffsignal.com and select the “Warranty & Returns”
link along the left column of our home page. If you have questions regarding this product please contact Technical Services, Monday - Friday, 8 am to 5 pm at 1.800.338.7337, press #4 to
skip the automated message. Questions or comments that do not require immediate attention may be emailed to [email protected].
1.800.338.7337. / www.soundoffsignal.com / Thank you for trusting us with your safety!
Please see reverse for
Technical Specifications
• Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances.
These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these
devices to ensure compliance.
• DO NOT connect this device to a strobe power supply. This product is self-contained and does not
require an external power supply.
ENFSLXWS 7.12
Important Information:
INSTALLATION:
Windshield should be clean and free
of grease or oil. The placement of the
windshield mount Nexus™ should
not restrict driver visibility and the
unit should be placed so that air bag
deployment will not be restricted. The
best place for unit is immediately
behind the rear-view mirror.
1) Press suction cups into the side
yokes of the light as shown in the
illustration.
2) Lightly moisten suction cups and
press unit firmly in place by pressing
the domed shape on the back of
each cup.
SAE CLASS 1 WINDSHIELD MOUNTS
TECHNICAL
SPECIFICATIONS
WINDSHIELD MOUNT NEXUS
Single Mount
Dimensions:
6.80”L x 1.43”H x
5.00”D
Double Mount
Dimensions:
11.35”L x 1.43”H x
5.00”D
Input Voltage: 10 - 16 Vdc
CURRENT CONSUMPTION
6, 12 Split &
18 Tri-Color
<1.0A @12.8 Vdc
9 LED Single Color <1.5A @ 12.8 Vdc
12 LED Single Color <2.0A @12.8 Vdc
INSTALL SUCTION CUPS BY INSERTING BASE
OF CUP THROUGH THE WIDE HOLE IN BRACKET
AND PULLING TOWARD SMALL HOLE.
LIGHT ASSEMBLY
SLIGHTLY LOOSEN SCREW
TO ADJUST UNIT BUT
DO NOT REMOVE
WINSHIELD SHROUD
FIRM
HORIZONTAL
CHECK FOR PROPER INSTALLATION:
1. All suction cups are pressed to windshield
as firmly as possible.
2. Unit is mounted horizontally.
3. Shroud fits tights against windshield.
SINGLE WINDSHIELD MOUNT NEXUS
DOUBLE WINDSHIELD MOUNT NEXUS
PATTERN
POWER ON/ OFF
ADJUSTMENT:
1) Slightly loosen, but DO NOT REMOVE,
pivot screws on each side of unit.
2) Slide light up until all four edges on shroud
are in contact with windshield.
3) Pivot light so that unit will project a
horizontal pattern
4) Retighten pivot screws. CAUTION! DO
NOT OVERTIGHTEN SCREWS AS UNIT CAN
BE DAMAGED.
CIGARETTE PLUG