SoundOff Signal nFORCE Recess Mount User Manual
Page 2
ENFSRS1(x) 03.14
RECESS MOUNT CUTOUT TEMPLATE
AFTER POWER IS ON, touching the WHITE wire to the ground
will allow you to change various setting on the module.
SLAVE MODE
The NFORCE™ is capable of being activated through the use of a user
supplied flasher by putting it in Slave Mode.
1. Permanently connect the NFORCE™ WHITE and BLACK wire to a good,
convenient ground.
2. Connect the NFORCE™ RED wire, through a 5amp fuse, to the output of
a +10-16Vdc switching flasher.
R0.46"
4.72"
1.65"
2.
1.800.338.7337 / www.soundoffsignal.com
SETUP TABLE
SECONDS
USER INTERFACE
FROM
TO
VISUAL FEEDBACK
ACTION TAKEN
0
1
STEADY-HIGH (60%)
FORWARD ONE PATTERN
1
2
STEADY-LOW (30%)
BACKWARD ONE PATTERN
2
3
OFF
COLOR SWAP (OFF OR ON )
3
4
STEADY - HIGH (60%)
SIMULTANEOUS OR ALTERNATE
4
5
STEADY - LOW (30%) SEPARATE COLOR CONTROL (OFF OR ON)
5
6
OFF
RESET TO PATTERN 1
6
7
STEADY-HIGH (60%)
FACTORY RESET (PATTERN 1, COLOR
SWAP: OFF, SEQUENCE TYPE:1)
SEPARATE COLOR CONTROL: OFF
If held longer than 7 seconds, the light will go back to flashing the current
pattern and no action will be taken.
PATTERN SELECT & SYNC
CONFIGURATION INSTRUCTIONS
Connecting the WHITE wire to power will allow you to use
the secondary function on your Nexus Secondary Light.
SECONDARY FUNCTION:
• 1-color module = Cruise Mode (10% brightness, non-
flashing)
• 2 - color modules = Separate Color Control (see Setup
Table) or Takedown (100% steady-burn of the 2nd color)
• 3 - color modules = Takedown (100% steady-burn of the
3rd color)
SETUP LIGHTS:
Simultaneous or Alternate Function
•1 or 2. The modules will flash simultaneously if they are set
to the same number. The modules will have an alternate flash
if set to different numbers.
Color swap
• Off or On. 2-color and 3-color modules, it changes which
color flashes first.
Separate color control (2 color lights only)
•Allows manual switching of flashing color. When this fea-
ture is programmed on the On state: the light will jump to the
first pattern of the 1-color patterns, you will only be able to
choose 1-color patterns, and Color Swap will be programmed
to Off. To select a 2-color pattern, program this feature to the
Off state.
*To turn of Seperate Color Control you
must do a factory reset.
*