SoundOff Signal nFORCE Deck Grille - Manual (Page 2)

ENFSLXGS 7.12
SECONDS USER INTERFACE
FROM TO VISUAL FEEDBACK ACTION TAKEN
0 1 STEADY-HIGH (60%) FORWARD ONE PATTERN
1 2 STEADY-LOW (30%) BACKWARD ONE PATTERN
2 3 OFF COLOR SWAP (OFF OR ON )
3 4 STEADY - HIGH SEQUENCE TYPE (1 OR 2)
4 5 STEADY - LOW RESET TO PATTERN 1
5 6 OFF
FACTORY RESET (PATTERN 1, COLOR
SWAP: OFF, SEQUENCE TYPE: 1)
If held longer than 6 seconds, the light will go back to flashing the current
pattern and no action will be taken.
PATTERN SELECT & SYNC
CONFIGURATION INSTRUCTIONS
Connecting the WHITE wire to power will
allow you to use the secondary feature on
your Nexus Secondary Light.
SECONDARY FEATURE:
• 1-color module = Cruise Mode
(10% brightness, non - flashing)
• 2 & 3 - color modules = Takedown
(100% Steady - burn)
- For 2-color modules this is the 2nd color
- For 3-color modules, this is the 3rd color
SETUP LIGHTS:
• Sequence type
-1 or 2. The modules will flash simultane-
ously if they are set to the same number.
The modules will have an alternate flash if
set to different numbers.
• Color swap
- Off or On. 2-color and 3-color modules, it
changes which color flashes first.
This is useful when syncing multiple lights
Touching the WHITE wire to the ground will allow
you to change various setting on the module.
SLAVE MODE
The NFORCE™ is capable of being activated through the use of a user
supplied flasher by putting it in Slave Mode.
1. Permanently connect the NFORCE™ WHITE and BLACK wire to a good,
convenient ground.
2. Connect the NFORCE™ RED wire, through a 5amp fuse, to the output of
a +10-16Vdc switching flasher.
0.20
2.36 1.31
SINGLE MOUNT DECK/ GRILLE TEMPLATE
HOLE 2X
“ “
“
0.22"
HOLE 4x
1.20"
3.43"
4.63"
DOUBLE MOUNT DECK/ GRILLE TEMPLATE