E-flite Advance 25e - Manual (Page 17)

17 E-flite Advance 25e ARF Assembly Manual
When mounting the 60-amp speed control for the
Power 32, make sure to secure the switch on the
speed control where it can be easily accessed.
 5. Connect the lead from the speed control to the
receiver using a 3-inch (76mm) servo extension.
 6. Apply the remaining hook and loop tape to the
bottom of the battery. This will keep the battery from
moving forward or aft in the fuselage.
 7. Use the hook and loop straps to secure the
battery to the battery tray.
 8. Turn on the transmitter. Connect the battery to the
power lead of the speed control. Check the rotation
of the motor to make sure it rotates counterclockwise
when viewed from the front of the fuselage. If not,
swap any two of the motor leads to correct the
direction of rotation.
Always balance your propeller. An unbalanced
propeller can cause vibrations to be transmitted
into the airframe, which could damage the
airframe or other components as well as
produce unwanted flight characteristics.
 9. Use the propeller adapter to secure the
propeller to the motor. Slide a 2.5mm-inch hex
wrench through the hole in the adapter to tighten
it, securing the propeller.
We recommend using the optional spinner
to enhance the looks of your model.