Brandmotion 1009-9517 - Manual (Page 9)

INSTALLATION INSTRUCTIONS
1009-9000-00 9 of 18
9 August 2011
23. Insert the rear connector of the supplied
chassis harness into the hole in the floor
pan of the under seat storage compartment.
(Figure 17)
Figure 17
24. Seat the grommet affixed to the supplied
chassis harness in the hole in the floor pan
of the under seat storage compartment by
firmly pressing it with your fingers. (Figure
18)
Figure 18
25. Route the front connector of the supplied
chassis harness through the seat riser
reinforcement hole. (Figure 19)
Figure 19
26. Reinstall carpet and reinstall three pushpins
that were removed earlier.
27. Route the supplied chassis harness around
the B-Pillar trim by lifting up on the trim and
feeding the wiring harness through to the
front. Continue to route the chassis harness
along the driver’s side front door opening sill
area. (Figures 20 & 21) Note: This will be a
tight fit, as the supplied chassis wiring
harness will run next to the truck’s existing
wiring harness.
Figure 20