Brandmotion 1009-9517 - Manual (Page 16)

INSTALLATION INSTRUCTIONS
1009-9000-00 16 of 18
9 August 2011
Figure 37
Figure 38
49. Route the camera connector and wiring
harness through the endgate and install the
supplied handle using a 8mm socket and the
existing hardware. (Figure 39)
Figure 39
50. Reinstall the handle bolts.
51. Reinstall the linkage rods and close the red
tabs around them using your fingers.
(Figure 40)
Figure 40
52. Route the supplied camera harness through
the pass-through hole in the inner brace of
the endgate. (Figure 41)
Figure 41