Brandmotion 1009-9517 - Manual (Page 7)

INSTALLATION INSTRUCTIONS
1009-9000-00 7 of 18
9 August 2011
11. Route the supplied interior harness under
leading edge of the driver’s side headliner
by gently separating the headliner from the
windshield and tucking the interior harness
into the gap with your fingers. (Figure 9)
Figure 9
12. Route the supplied interior harness down
the driver’s side A-Pillar and wire tie it to the
existing wires using three wire ties. (Figure
10)
Figure 10
13. Route the supplied interior harness through
the A-pillar opening. (Figure 11)
Figure 11
14. Route the supplied interior harness
connector and wires behind the green left
headliner connector in the cavity that was
exposed by removing the driver’s side end
of dash cap. Wire tie the supplied interior
harness to existing wires using one wire tie
(Figure 12).
Figure 12
15. Install the supplied mirror by placing the
mirror mount over the windshield mounting
button and sliding it forward. Use a T20
Torx driver to tighten the screw on the
mirror mount.
16. Plug the supplied interior harness connector
into the back of the supplied mirror.