Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 83)

A-14 GV3000/SE Operator Interface Module (OIM) User Guide, Version 2.0
P.037 PRESET SPEED 7
P.038 PRESET SPEED 8
P.039 ENCODER LOSS ENABLE
P.040 MOTOR OVERLOAD ENABLE
P.041 MOTOR OVERLOAD TYPE SEL
P.042 LINE DIP RIDE THRU TM
P.043 FLT AUTO RESET COUNTS
P.044 FLT AUTO RESET TIME
P.045 OUTPUT PHASE LOSS EN
P.047 CARRIER FREQ - KHZ
P.048 REGULATION TYPE
P.049 DEFAULTS TYPE
P.050 RESTORE DEFAULTS
P.051 PROGRAMMING DISABLE
P.052 AUTO/MAN KEY DISABLE
P.053 MAN REF PRESET ENABLE
P.054 LEVEL SENSE START ENABLE
P.055 STOP/RST KEY DISABLE
P.060 NETW DROP NUMBER
P.061 NETW CONNECT TYPE
P.062 NETW COM LOSS RESP
P.063 NETW REF SOURCE
P.065 NETW TYPE AND VERS
P.066 OUTPUT REG 1 SOURCE
P.067 OUTPUT REG 2 SOURCE
P.068 OUTPUT REG 3 SOURCE
P.069 OUTPUT REG 4 SOURCE
P.090 DIAGNOSTICS SELECT
P.091 DIAGNOSTICS DISPLY
P.095 P/M OUTPUT AMPS
P.098 SOFTWARE VERSION NUM
P.099 SELECTED P/M TYPE
H.000 MOTOR NAMEPL VOLTS
H.001 MOTOR NAMEPL BASE FRQ
H.002 MOTOR NAMEPL AMPS
H.003 TORQUE BOOST VOLTAGE
H.004 SLIP COMPENSATION
H.005 DC BRAKING ENABLE
Table A.2 – OIM Parameters Listed by Parameter Number (Continued)
Parameter Number OIM Parameter Name