Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 3)

Contents I
C
ONTENTS
Chapter 1 Introduction to the OIM
1.1
Differences Between the OIM and the Front Panel Keypad/Display ............... 1-1
1.2 Related Publications ........................................................................................ 1-2
1.3 Getting Assistance from Reliance Electric....................................................... 1-3
Chapter 2 Description of the OIM Keypad, Display, and Indicators
2.1
The Keypad ..................................................................................................... 2-1
2.2 The Display...................................................................................................... 2-5
2.2.1 Drive Status Indicators .......................................................................... 2-5
2.2.2 Key Indicators ....................................................................................... 2-6
2.2.3 Special Display Characters ................................................................... 2-7
Chapter 3 Installing, Powering, and Adjusting the OIM
3.1
Installing or Replacing the OIM ....................................................................... 3-1
3.1.1 OIM Kit Contents ................................................................................... 3-1
3.1.2 Equipment Needed to Install or Replace the OIM ................................. 3-2
3.1.3 Installing the OIM .................................................................................. 3-2
3.1.4 Replacing the OIM ................................................................................ 3-4
3.2 Powering Up the OIM ...................................................................................... 3-4
3.3 Adjusting the Screen Contrast ......................................................................... 3-5
3.4 Changing the Language Displayed on the OIM............................................... 3-6
3.5 Scaling Speed Units for Your Application ........................................................ 3-7
3.5.1 Scaling Speed Units .............................................................................. 3-7
3.5.2 Setting OTHER Speed Units ................................................................. 3-8
Chapter 4 Basics of Programming the Drive Using the OIM
4.1
Accessing OIM Menus and Parameters .......................................................... 4-1
4.1.1 Accessing the Menus ............................................................................ 4-1
4.1.2 Using Help in Program Mode ................................................................ 4-2
4.1.3 Accessing the Parameters .................................................................... 4-4
4.1.4 Viewing Parameter Values .................................................................... 4-6
4.1.5 Changing Parameter Values ................................................................. 4-6
4.1.6 Parameter Values that Cannot be Changed ......................................... 4-8
4.2 Using a Password to Protect Programming..................................................... 4-8
4.3 Restoring Factory Default General Parameters .............................................. 4-9
Chapter 5 Using Quick Start to Program the Drive
5.1
Preparing for Quick Start ................................................................................. 5-1
5.2 Using the Quick Start Exit Menu...................................................................... 5-2
5.3 Programming the Drive Using Quick Start....................................................... 5-3
5.4 Self-Tuning Drives Programmed for Vector Regulation .................................. 5-4
5.4.1 Setting Up the OIM for Self-Tuning ....................................................... 5-5
5.4.2 Performing Self-Tuning ......................................................................... 5-5
5.4.3 Exiting Before Self-Tuning is Complete................................................. 5-7
5.4.4 What To Do If a Fault Occurs During Self-Tuning................................. 5-7
5.5 Quick Start Parameter Descriptions ................................................................ 5-8