Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 74)

OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers A-5
MOTOR NAMEPL RPM Motor Nameplate RPM Input U.005 Quick Start (Vector)
Motor Data (Vector)
MOTOR NAMEPL
VOLTS Motor Nameplate Volts Input H.000 Motor Data (V/Hz)
Quick Start (V/Hz)
MOTOR NAMEPL
VOLTS Motor Nameplate Volts Input U.007 Quick Start (Vector)
Motor Data (Vector)
MOTOR OVERLOAD
ENABLE Motor Overload Enable Input P.040 Application Setup
(V/Hz and Vector)
⇒
Fault Functions
MOTOR OVERLOAD
TYPE Motor Overload Type Input P.041 Application Setup
(V/Hz and Vector)
⇒
Fault Functions
MOTOR POLES Motor Poles Input U.002 Quick Start (Vector)
Motor Data (Vector)
MOTOR TOP SPEED Motor Top Speed Input U.017 Application Setup
(Vector)
NETW CONNECT TYPE Network Connection
Type
Input P.061 Option Port
Configuration
⇒
Network Configuration
NETW DROP NUMBER Network Drop Number Input P.060 Option Port
Configuration
⇒
Network Configuration
NETW COM LOSS
RESP Option Port:
Communication Loss
Response Input P.062 Option Port
Configuration
⇒
Network Configuration
NETW REF SOURCE Option Port: Network
Reference Source Input P.063 Option Port
Configuration
⇒
Network Configuration
NETW TRIM
REF SOURCE Option Port: Network
Trim Reference Source Input P.064 Option Port
Configuration
⇒
Network Configuration
NETW TYPE AND
VERS Option Port:
Type and Version Read only P.065 Option Port
Configuration
⇒
Network Configuration
OCL FEEDBACK
SOURCE* Outer Control Loop
Feedback Source Input U.040 Performance Tuning
(Vector)
⇒
Outer Control
Loop
OCL INTEGRAL GAIN* Outer Control Loop
Integral Gain Input U.046 Performance Tuning
(Vector)
⇒
Outer Control
Loop
OCL LEAD/LAG LOW
FREQ* Outer Control Loop
Lead/Lag Low
Frequency Input U.042 Performance Tuning
(Vector)
⇒
Outer Control
Loop
Table A.1 – OIM Parameters Cross-Referenced to Software I/M Parameters and Parameter Numbers (Continued)
OIM Parameter Name
Software I/M
Parameter Name Type
Parameter
Number OIM Menu Path