Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 21)

Installing, Powering, and Adjusting the OIM 3-1
C
HAPTER
3
Installing, Powering,
and Adjusting the OIM
This chapter tells you how to install the OIM, what to expect on power up, and how to
make adjustments you might need for your application.
3.1 Installing or Replacing the OIM
Installation consists of mounting the OIM and connecting it to the GV3000/SE drive.
Replacing the OIM consists of removing the old OIM and installing a new one.
Note that the OIM is connected to the RS-232 serial port on the GV3000/SE Regulator
board. Therefore, it cannot be used at the same time that another serial connection is
in effect, such as the one required by the CS3000 software
3.1.1 OIM Kit Contents
Table 3.1 lists the contents of the OIM kit (M/N 2RK3000).
!
ATTENTION: Only qualified personnel familiar with the construction and
operation of this equipment and the hazards involved should install,
adjust, operate, and/or service this equipment. Read and understand
this manual in its entirety before proceeding. Failure to observe this
precaution could result in severe bodily injury or loss of life.
ATTENTION: The user must provide an external, hardwired emergency
stop circuit outside the drive circuitry. This circuit must disable the
system in case of improper operation or OIM failure. Uncontrolled
machine operation can result if this procedure is not followed. Failure
to observe this precaution could result in bodily injury.
Table 3.1 – OIM Kit Contents
Description Quantity Part Number
OIM Assembly 1 807303-R
Serial Cable 1 610273-49S
Gasket 1 410273-4B
M4x125mm CCWS Screws 2 419062-1PGM
Bezel 1 179099-8