Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 37)

Basics of Programming the Drive Using the OIM 4-7
.
Step 4. If the existing value is shown, go to step 5. If you see a list of options:
a. Move the cursor to the option you want to select.
b. Press to accept the option.
c. Go to step 6.
Step 5. If you see the existing value:
a. Use and to move the cursor ( ) to the digit or sign (+ or -) that
needs to change.
b. Press or to change the number or sign. When changing the
numbers:
• If the right-most digit is increased past 9, the digit to the left is increased
by one. Incrementing any other digit does not increase the digit to the
left. For example, if 19 is displayed, pressing
changes the value
to 200. However, if 1 9 is displayed, pressing changes the value
to 109.
• If the field is blank and you fill in the left-most digit, the digits to the right
are automatically filled in with zeros.
• You cannot enter a number out of the parameter’s range. The drive
clamps values to a minimum or maximum.
• Press to restore the previous value. You can then either change
the value or press again to exit the parameter entry screen
without accepting any changes.
• Press to save the changed value. Go to step 6.
Step 6. Press to return to the list of parameters.
Step 7. Record changes to parameter values in Appendix C.
Figure 4.10 – Parameter Entry Screen with a List of Options
9
9
9