Rockwell Automation GV3000/SE Operator Interface Module (OIM) User Guide - Manual (Page 68)

Troubleshooting the Drive Using the OIM 7-9
7.7 Alarm and Fault Names Cross-Referenced to Front
Panel Keypad/Display Codes
The following tables list the fault and alarm messages that can occur on the OIM. They
are cross-referenced to the fault and alarm messages as listed in chapter 5 of the
software I/M.
Table 7.3 – List of Alarms Cross-Referenced to Front Panel Keypad/Display Alarm Codes
OIM Alarm Name
Front Panel
Keypad/Display
Code
Software I/M
Alarm Description
ANALOG IN SIGNAL
LOSS
1
1
Only supported with GV3000/SE drive version 6.03 and later.
AIn Analog input signal loss
HIGH DC BUS VOLTAGE
2
2
Only supported with GV3000/SE drive versions 6.0 and later.
HIdc High DC bus voltage
LOW AC INPUT LINE LIL Low AC input line
VECTOR SELF-TUNING
ACTIVE S-Ac Vector self-tuning active
VECTOR SELF-TUNING
ENABLED S-En Vector self-tuning enabled
V/HZ IDENT PROCEDURE
ACTIVE I-Ac V/Hz identification procedure
active
V/HZ IDENT PROCEDURE
ENABLED I-En V/Hz identification procedure
enabled
Table 7.4 – List of Fault Codes Cross-Referenced to Front Panel Keypad/Display Fault Codes
OIM Fault Name
Front Panel
Keypad/Display
Code
Software I/M
Fault Description
ANALOG IN SIGNAL
LOSS
1
AIn Analog input signal loss
ASYMMETRICAL BUS
CHARGE UbS Asymmetrical bus charge
COMM LOSS BETWEEN
REGULATOR/PC SrL Communication loss between
regulator/PC
DC BUS CHARGING
BYPASS CONTACTOR bYC DC bus charging bypass
contactor
DEFAULT PARAMETER
RESTORE CHS Default parameter restore
(checksum error)
DRIVE
OVERTEMPERATURE OH Drive overtemperature
DRIVE POWER
ELECTRONIC OVERLOAD PUo Drive power electronic overload
ENCODER LOSS EL Encoder loss
FUNCTION LOSS FL Function loss