Rockwell Automation Motion Control PTO Application Building Block - Manual (Page 77)

Rockwell Automation Publication CC-QS033A-EN-P - February 2014 77
Motion Axis Setup for PTO Building Block Appendix C
If your project was generated by CCAT System Design Assistant, use the name given when you set up the PTO
application. By default, the first PTO application is call ServoDrive1 and subsequent applications are called
ServoDrive2 and ServoDrive3.
The names of axes for PTO applications created with Connect Components Workbench motion configuration are
shown here.
2. Select your preferred PTO channel.
Each PTO channel has its own corresponding Pulse Output and Direction Output terminal. PTO channel 0 has
been selected for this building block. Pulse and direction signal are generated from output 0 and 3.