Rockwell Automation MD65 EtherNet/IP Communication Module - Manual (Page 99)

Troubleshooting the Module and Network 9-11
9.4 Viewing and Clearing Events
The module maintains an event queue that reports the history of its
actions. You can view the event queue using V*S Utilities software
(3.01).
To View and Clear Events
Events
Many events in the event queue occur under normal operation.
However, if you encounter communication problems, the events can
help you or Rockwell Automation personnel troubleshoot the
problem. Table 9.7 lists events that may appear in the event queue.
Figure 9.2 – V*S Utilities Event View/Clear Screen
MDCOMM-ENET
Table 9.7 – Event Codes and Descriptions
Code Event Description
Module Events
0 No Event Text displayed in an empty event queue entry.
1 Normal Startup Power is applied to the module.
2 Manual Reset The module was reset from the “Reset Module”
parameter.
3 Watchdog T/O Flt The software watchdog detected a failure and
reset the module.
4 App Undated The application firmware has been flash updated.
5 Boot Updated The boot firmware has been flash updated.
6 EEPROM Sum Flt The EEPROM checksum/CRC is incorrect. The
functionality of the module will be limited. Default
parameter values must be loaded to clear the
condition.
7-9 Reserved
MDI Events