Configure df1 communication, Save the application, Configure df1 communication save the application – Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual User Manual

Page 62

Publication 2711-QS003D-EN-P - June 2009

Chapter 4 Configuring Communication

Configure DF1
Communication

This section defines the communication settings for a DF1 PanelView
terminal and a PLC-5 or SLC 5/03, /04, /05 controller through
channel 0.

1. Select Application>Settings.

2. On the Terminal Setup tab, click the Comms. Setup button.

Set the properties as shown.

3. Click OK until you exit the Application Settings dialog.

Save the application

Select File>Save or click the Save tool on the toolbar.

Important: LC_1 is entered to
match the Node name in the
Tag Editor.

Select the logic controller you
are using.

Verify that the catalog number and firmware
number matches your hardware.