4 - configuring communication, Chapter 4, Configuring communication – Rockwell Automation 2711-ND3 PanelBuilder32 Quick Start Manual User Manual
Page 55: Chapter

55
Publication 2711-QS003D-EN-P - June 2009
55
Chapter
4
Configuring Communication
This chapter shows how to configure network communication for
your PanelView terminal and logic controller. Configuration is
provided for the following communication protocols:
•
DH-485 - configures a DH-485 PanelView terminal and an SLC
or MicroLogix controller
•
DH+ - configures a DH+ PanelView terminal and a PLC-5, SLC
5/04, or ControlLogix DH+ module.
•
Remote I/O - configures a Remote I/O terminal and a PLC-5,
SLC 5/03, 5/04 or 5/05 controller with a 1747-SN/B scanner or
ControlLogix DHRIO module.
•
ControlNet - configures a ControlNet PanelView terminal and a
ControlLogix CNet module or PLC-5 controller using scheduled
or unscheduled messaging.
•
DeviceNet - configures a DeviceNet PanelView terminal to
communicate as a slave device to a PLC-5, SLC, or ControlLogix
controller with a DeviceNet module.
•
EtherNet/IP - configures an EtherNet/IP PanelView terminal to
communicate with a ControlLogix controller (with 1756-ENET/B
or /ENBx module), PLC-5E or SLC 5/05 on an EtherNet/IP
network.
•
DF1- configures a DF1 PanelView terminal and a PLC-5, SLC
5/03, 5/04, 5/05, MicroLogix, or ControlLogix controller. For a
ControlLogix serial port, select PLC-5 controller type.
Refer to the section that is appropriate for your terminal.