Rockwell Automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL - Manual (Page 27)

2–5 Installing the Software
Publication 2706-6.2
If you are using a DH+ link and want to enable PLC PassThrough
file transfers, you must perform the following additional steps after
completing the basic installation described above.
The following paragraphs outline only the most essential information
required to install and use PassThrough file transfers on a DH+ link.
Refer to the instructions that came with your DH+ add-in board.
Install and Configure Your DH+ Communication Interface Card
Install and configure your DH+ communication interface card. Refer
to the instructions that came with the card for information on how to
install and configure it. Currently the following DH+ cards are
supported by the Offline Programming Software:
– 1784-PCMK – 1784-KL
– 1770-KF2 – 1784-KT
– 1784-KT2 – 1784-KTX
Important: Be sure to record the IRQ and Card address for each
interface card. You will need to know them later in the
configuration process.
Install the Offline Programming Software
Perform the basic installation procedure described earlier in this
chapter to install the Offline Programming Software on your
personal computer.
Software Installation
for DH+ PLC PassThrough