Rockwell Automation 2706-LSW DL40 PLUS OFFLINE PROG.SFTWR.USER MANUAL - Manual (Page 20)

1–13 Overview of the DL40 Plus
Publication 2706-6.2
The following PLCs and SLCs support Remote I/O communications
with the DL40 Plus.
•
PLC-5/11, 5/15
➀
, 5/20, 5/25, 5/30, 5/40, 5/60, 5/80, 5/250
•
PLC-2, PLC-5/10, 5/12 with Catalog Number 1771-SN Scanner
•
SLC-5/02, 5/03, 5/04 with Catalog Number 1747-SN Scanner ➁
➀
If you are using a PLC-5/15 with partial rack addressing and block transfers, you must use Series
B, Rev. J or later.
➁
Block Transfer requires a Series B or later Scanner.
PassThrough Support over a DH+ Link
PLC-5 Remote I/O PassThrough lets you upload and download
message files between a computer and a DL40 Plus connected by
Remote I/O to a PLC on the DH+ link. Refer to Appendix D for an
example application. Separate wiring from the computer to the
DL40 Plus is not required. For a list of supported controllers, see
table below. Refer to Appendix D for additional instructions.
Computer
DH+ Network
Remote I/O Link Remote I/O Link
DL40 Plus DL40 Plus DL40 Plus
PLCs supporting PassThrough over a DH+ link
Computer interface boards for PassThrough
PLC Types Series Revision Catalog No. Description
PLC-5/11 All All 1784-KT 1 /
2
-slot interface board
PLC-5/15 B N or later 1784-KTX 1 /
2
-slot interface board
PLC 5/20 All All 1784-KL
Interface board for Allen-Bradley
1784-T45 or -T47
PLC 5/25 A J or later 1784-KT2 Interface module for IBM PS2
PLC 5/30 A B or later 1770-KF2 Serial to DH+ interface module
PLC 5/40
A
B
E or later 1784-PCMK PCMCIA interface board
PLC 5/60
A
B
B or later
PLC 5/80 All All
PLC 5/250 All All
Controller Support
for Remote I/O