Rockwell Automation 2755 AtomScan Bar Code Reader - Manual (Page 87)

6–2 Hardware Operation
Publication 2755-6.9
Function Command Action
Software Reset (does not save for power-on)
Software Reset/Restore Default
Software Reset/Read NOVRAM
Program Management Enter Configuration Mode Program Management
Software Reset/Save Parameters for Power-on
Restore/Save Default Configuration for Power-on
Save Scanner Type, SPS, and Gain for Power-on
Enable Laser Scanning (Laser On)
Disable Laser Scanning (Laser Off)
Motor On
Device Control
Motor Off
Relay-1 Pulse
Relay-2 Pulse
Autodiscriminate All Codes
Enable Code 39 Only ➀
Code Types
Enable Codabar Only ➀
Enable I 2 of 5 Only ➀
No Read Counter
No Read Counter Reset
Trigger Counter
Trigger Counter Reset
Counter
Match Code/Good Read Counter
Match Code/Good Read Counter Reset
Mismatch Counter
Mismatch Counter Reset
Enter Decode Rate Test
Test Enter Extended Decode Rate Test Test
Exit Decode Rate Test; Exit Extended Decode Rate Test
<#> Display Software Part Number
Display Checksum of EPROM
Show Scanner Status
Status
Show Software Status (Send Status Byte, Part Number, and ROM
Checksum. Display NOVRAM Checksum at Power Up, then Display
Current NOVRAM Checksum)
Enable Match Code Option ➀
Disable Match Code Option ➀
Store Next Label Scanned as Master Label
Master Label
<)XXXX)> Download Master Label Information
<)> Request Master Label Information
<))> Delete Master Label Information
➀
The command can also be set in the configuration menu or with a serial configuration command.