Rockwell Automation 2090-XBxxx Resistive Brake Module Installation Instructions - Manual (Page 16)

Publication 2090-IN009F-EN-P — November 2004
16 Resistive Brake Module Installation Instructions
Applying the Power Cable Shield Clamp
To apply your power cable shield clamp:
1. Use a small flat blade screwdriver to depress the spring loaded clamping
plate as shown in Figure 11.
Figure 11
Depressing the Spring Clamp
2. Position the exposed portion of the cable braid directly in line with the
clamp.
3. Release the spring, making sure the cable and cable braid are held secure
by the clamp.
4. Attach tie wrap around cable and clamp, if additional strain relief is
required (refer to Figure 12).
Figure 12
Motor Cable and Clamp
Flat Blade Screwdriver
3.5 mm (0.14 in.) tip
Cable Clamp
Screwdriver
tip in slot
Tie Wrap
Outer Insulation
Motor
Cable
Exposed Braid
(under clamp)
Cable Clamp