Rockwell Automation 8720MC High Performance Drives Installation Manual - Manual (Page 83)

Publication 8720MC-IN001D-EN-P — December 2002
Connecting Your 8720MC 3-21
Wiring the Motor Brake
Connector (MP-Series
Motors Only) The brake wires are in a separate brake cable and the motor has a
brake connector. For the MP-Series motor, use the
2090-UXNBMP-18Sxx brake cable or the 2090-MPBC-S cable
connector kit.
Refer to Figure B.6 in Appendix B for the motor brake interconnect
diagram.
To wire your motor brake connector:
1. Route the motor brake cable to your drive.
2.
3. Tighten the connections.
4. Gently pull on each wire to make sure it does not come out of its
terminal. Re-insert and tighten any loose wires.
5. Go to Connecting Your SERCOS Fiber Optic Cables, Connecting to
the External Active Shunt Module, or Understanding Feedback and
I/O Cables as needed for you application.
Insert the motor
brake wires from the
MP-Series Motor: Into P5 Connector on
the Drive:
Pin Signal
A / BR+ P5-8 Relay 2
C / BR- P5-9 Relay 2