Rockwell Automation 2707-L40X_L8X_V40X DTAM Plus Operator Interface Module Installation Instructions - Manual (Page 44)

Chapter 3
Using the Function Menu
3–2
Many DTAM Plus functions are accessed from the Function menu. To
access the Function menu, press the [F] key on the keypad. All other
functions are halted when the menu is displayed.
Note: To enable the F (Function) key, DIP switch SW-4 must be set ON.
The Function menu provides access to these functions:
1 C-Port 5 Special
2 P-Port 6 Term
3 Clk/Cal 7 Test
4 Reset 8 Other
Select a menu item by pressing the corresponding numeric key [1]
! [8].
The menu structure is shown below:
Resets the DTAM Plus
Configures the Comm Port Special Controller Operations
1 C-Port 5 Special
2 P-Port 6 Term
3 Clk/Cal 7 Test
4 Reset 8 Other
Select Item:
1 Baud Rate
4 Exit
2 Data Bits
3 Parity
1 Baud Rate 5 L/Feed
2 Data Bits 6 Penable
3 Parity 7 Exit
4 Hndshk
Configures the Printer Port
Sets the Clock /Calendar
1 Half Duplex
2 Line Feed Enable
3 Cursor Enable
4 Exit
Configures Terminal Mode
Screen display depends
upon operating system.
Refer to Appendix C.
1 Simulate 5 Master C
2 BL / INT 6 Scale E
3 Contrast 7 Exit
4 Prn Scrn
DTAM Plus Diagnostic
NEXT to Select Test
ENTER to Initiate
[Test Function]
Performs Self Tests
Accesses Additional Functions
Function Key Menu