Rockwell Automation 6008-SI IBM PC I/O SCNNR 6008-SI - Manual (Page 123)

Chapter 10
User Diagnostic Program
10-11
Enter a BT number (1 up to the total number of BTs). The program
displays the details of that BT, including its confirmation status, and
repeats the prompt. At any time you can answer the above prompt with a
0
(zero) if you want to re-display the completion summary. When you’ve
seen all the details you want, enter an X to return to the main command
prompt. Finally, the program lets the operator enter numbers repetitively
to view the details of the indicated BTs.
You must repeat the multiple block transfer steps each time new
information is required. Repeated requests of a specific block transfer
module will show the same data.
Continuous block transfers
The
C
subcommand of the
BT
command asks you for details of a BT read or
write (see “Single block transfers” above) and executes that BT again and
again until you press any keyboard key. The reason is displayed for each
BT that fails; otherwise the only display is the number of BTs executed.