Rockwell Automation 1769-IR6 Compact I/O 1769-IR6 RTD/Resistance Input Module - Manual (Page 38)

38 Rockwell Automation Publication 1769-UM005B-EN-P - March 2012
Chapter 3 Installation and Wiring
Removing and Replacing the Terminal Block
When wiring the module, you do not have to remove the terminal block. If you
remove the terminal block, use the write-on label located on the side of the
terminal block to identify the module location and type.
To remove the terminal block, loosen the upper and lower retaining screws.
The terminal block will back away from the module as you remove the screws.
When replacing the terminal block, torque the retaining screws to 0.46 Nm
(4.1 in-lbs).
SLOT # _____
MODULE TYPE ______
wiring the
finger-safe
terminal block
upper retaining screw
lower retaining screw