Rockwell Automation 1747-ACNR15 ControlNet Adapter Module User Manual User Manual
Page 18
Publication 1747-UM003A-EN-P
2-6 Installing Your ControlNet Adapter Module
Connecting Programming
Terminals to the Network
via the NAP
You can connect programming terminals to the ControlNet network by
connecting to the network access port (NAP). Two methods are shown below.
Using 1784-KTC or -KTCx Communication Card and NAP
Programming Terminal
1784-KTC or
-KTCx
1786-CP
(1)
ControlNet
product
ControlNet network
Using 1770-KFC Communication Interface and NAP
Programming Terminal
1770-KFC
1786-CP
(1)
Serial or Parallel
Connection
ControlNet
product
ControlNet Network
(1) The 1786-CP cable can be plugged into any ControlNet product’s NAP to provide
programming capability on the ControlNet network. A programming terminal connected
through this cable is counted as a node and must have a unique address.
ATTENTION
!!!!
Use the 1786-CP cable when connecting a programming
terminal to the network through NAPs. Using a
commercially available RJ-style cable could result in
possible network failures.