Rockwell Automation 1305 AC Drive, Series A and B, Firmware 4.xx-5.xx - Manual (Page 73)

Chapter Programming 5
5-1
CHAPTER OBJECTIVES
Chapter 5 describes all parameters for Bulletin 1305 drives.
Parameters are divided into groups for ease of programming
and operator access. Grouping replaces a sequentially
numerical parameter list with functional parameter groups that
increases operator efficiency and helps to reduce programming
time. For most applications, this means simplicity at startup
with minimum drive tuning.
CHAPTER CONVENTIONS
1. All parameters required for any given drive function will be
contained within a group, eliminating the need to change
groups to complete a function.
2. To help differentiate parameter names and display text from
other text in this manual, the following conventions will be
used – Parameter Names will appear in [Brackets] – Display
Text will appear in ‘‘Quotes.”
3. Parameter information in this chapter is presented for users
who have a Human Interface Module (HIM) installed. For
those users without a HIM installed, the drive can be
operated using the factory default values for each parameter
or parameter values can be changed through the serial port.
FUNCTION INDEX
The Function Index shown provides a directory of various drive
functions. The Page Number will direct you to the parameters associated
with each function.
Function Page # Function Page #
Accel/Decel Time 5-9
M
5-6, 5-8, 5-28,
Accel/Decel Selection 5-30
MOP
6 8 8
5-31, 5-49, 5-53
Analog Invert 5-21 Motor Unbalance➀ 5-36
Auto-Restart/
Run On Power Up 5-33 Output Configuration
Overload Protection 5-37
5-12
Current Limiting 5-11, 5-13 Preset Frequencies 5-27, 5-29, 5-33
Custom Volts/Hz 5-15 Process Display 5-56
DC Boost 5-16, 5-17, 5-18,
5-19 PWM Freq. Derating
Ramp to Stop 5-20
5-11
DC Brake-to-Stop 5-11, 5-22, 5-23 S-Curve Acceleration 5-33, 5-34
Fan/Pump Volts/Hz 5-18 Skip Frequencies 5-27, 5-28
Fault Buffer History 5-41 Standard Boost V/Hz 5-18
Frequency Select 5-25 Standard Volts/Hz 5-16
Freq. Source Select 5-29 Start/Run Boost 5-19
Line Loss Fault 5-40, 5-41
Min/Max Freq. 5-10, 5-11, 5-12
➀ FRN 4.01 and below only.
PARAMETER FLOW CHART
The chart provided on pages 5-2 and 5-3 highlights each group of
parameters and lists all parameters for each of the 13 groups. Parameters
that appear in more than one group are shown in bold. Parameter
numbers are shown in parenthesis immediately after the parameter name.
An example of how to program a parameter is shown on page 5-4.