Rockwell Automation 1305 AC Drive, Series A and B, Firmware 4.xx-5.xx - Manual (Page 163)

Appendix B – Serial Communications
B-15
Table B.5 “Display Unit” Equivalent to Parameter Text Descriptions (continued)
Parameter
No.
Parameter
Name
Text Display
Unit
47 Language “English” 0
“Alternate Language” 1
51 Clear Fault “Ready” 0
“Clear Fault” 1
52 Compensation “No Comp.” 0
“Comp.” 1
57 S-Curve
e
Disabled 0 S urve
Enable
Enabled 1
64 Set Defaults “Ready” 0
“Store to EE” 1
“Recll frm EE” 2
“Default Init” 3
69 Drive Direction “Forward” 0
“Reverse” 1
72 Upper Presets Disabled 0
Enabled 1
Parameter
No.
Parameter
Name
Text Display
Unit
81 4-20mA Loss Sel “Min/Alarm” 0
“Stop/Fault” 1
“Hold/Alarm” 2
“Max/Alarm” 3
“Pre1/Alarm” 4
82 Curr Lim Trip En “Default Run“ 0
“Trip @ I Lmt” 1
84 Analog Invert Disabled 0
Enabled 1
90 Output Config 1 “At Speed” 0
91
u pu
Output Config 2 “Above Freq” 1
“Running” 2
“Faulted” 3
“Alarm” 4
“Balanced” ➀ ➁
‘‘Above Curr” ➀ ➁
143 Cable Length “Short“ 0
“Long” 1
➀ FRN 4.01 and below only. “Balanced” unit display is “5” and “Above Current” unit
display is “6”.
➁ FRN 5.01 and above only. “Above Current” unit display is “5”.