Rockwell Automation 1336R REGEN LINE REG - Manual (Page 51)

Regenerative DC Bus Supply Operation 2–35
Programming
Parameter No. 27
Display Units Bits
Parameter Type Read/Write
Factory Default 11100
Min/Max Value N/A
Drive Units N/A
Fault Select 1
This parameter enables or disables faults as defined by the first (5) bits of a (16) bit word. The
[Fault Select1] parameter may be set while the 1336 REGEN Converter is enabled.
Parameter No. 28
Display Units Number
Parameter Type Read/Write
Factory Default 5
Min/Max Value 1/32
Drive Units N/A
HIM Default Display Parameter
This parameter sets which of the previous parameters will be displayed after 1336 REGEN
Converter power-up. The [HIM Display Param] parameter may be set while the 1336 REGEN
Converter is enabled.
S e l e c t 1 a u l t F
0 0 2 7 1 X X 1 1 X
Bit 2 Bit 1 Bit 0
0 = SCANport 1 Timeout Disabled 1 = SCANport 1 Timeout Enabled
0 = SCANport 2 Timeout Disabled 1 = SCANport 2 Timeout Enabled
0 = Phase Mismatch Fault Disabled 1 = Phase Mismatch Fault Enabled
0 = Open Precharge Fuse Fault Disabled1 = Open Precharge Fuse Fault Enable
0 = PLL Fault Disabled
1 = PLL Fault Enabled
Bit 3 Bit 4
s p l a y P r m i I M D H
5 2 8