Rockwell Automation 1336VT AC DRIVE 5-300AMP (2-160KW) PROGRAMMING MANUAL - Manual (Page 5)

Preface
P-1
Manual Objective
The 1336VT Programming Manual is designed to be read and used like an
ordinary textbook. Read the manual once from the beginning in the order
presented to gain basic knowledge about your drive. Each chapter builds
upon information presented in the previous chapter. Become familiar with
tasks that must be performed in a sequence for safety and successful
completion. To assure successful installation and operation, the material
presented must be thoroughly read and understood before proceeding.
Particular attention must be directed to the Attention and Important
statements throughout the manual.
This manual defines the parameter and parameter values used in 1336VT
drives with Main Control Board Firmware Version 1.01 to 2.01, and Base
Driver/Power Supply Board Firmware Versions 1.01 to 3.01. At the back
of this manual is a parameter setting chart that provides minimum and
maximum parameter values, factory parameter settings, and a place to
record any settings that were changed during programming. Also provided
is a detailed Run and Start Boost setup procedure in Appendix A.
Important: Read and use the Hardware Manual first. Retain this manual
for future reference.
Important: The Handheld Programming Terminal
(Cat. No. 1336-MOD-E1) firmware must be upgraded with Kit SP-148340
(Version 2.01) to be compatible with drive firmware Version 2.01 and 3.01.
The Monitor Display (Cat. No. 1336-MOD-E2) firmware must be
upgraded with Kit SP-148341 (Version 2.01) to be compatible with drive
firmware Version 2.01 and 3.01.