Rockwell Automation 1391 USER MNL/DIGITAL AC SERVO DR - Manual (Page 43)

Chapter 6
Programming
6-6
Accessing Parameter Levels To help guard against access to advanced programming levels by untrained
personnel, special key combinations must be pressed to gain access.
When power is first applied to the 1391-DES the Basic Display (see
Figure 6.4) will be shown. The Basic Display alternates (every 2 seconds)
between the two displays shown. The alternating display indicates that the
drive is functioning normally. If for some reason the display does not
alternate or is not shown, refer to Chapter 11, Troubleshooting.
Figure 6.4
1391-DES Basic Display
The three parameter levels can be accessed by using the key combinations
described below. The parameter level can be confirmed by observing the
number of dots in the upper left corner of the display.
■ To Access the View Level
Press the Down Arrow key once, the View Level will be active.
Enter
■ To Access the Modify Level
Press the up, down and left arrow keys simultaneously and release.
Enter
■ To Access the Maintenance Level
a) Press the up, down and left arrow keys simultaneously,
then within 4 seconds . . .
b) simultaneously press the up, left arrow and Enter keys and release.
within 4 seconds, simultaneously press
Enter
Enter
■ To Return to the Basic Display
Press the Up Arrow and Enter keys simultaneously to return to the Basic
Display.