Commissioning the option module – Rockwell Automation 20-750-CNETC PowerFlex Coaxial ControlNet Option Module User Manual

Page 23

Text mode
Original mode

Rockwell Automation Publication 750COM-UM003B-EN-P - November 2012

Installing the Option Module

Chapter 2

Commissioning the Option
Module

To commission the option module, you must set a unique network node address.
See the

Glossary

for details about node addresses. When using the Node Address

switches, see

Setting the Node Address Switches on page 18

for details.

IMPORTANT

New settings are recognized only when power is applied to the option module
or it is reset. After you change parameter settings, cycle power or reset the
option module.