Rockwell Automation 20-750-CNETC PowerFlex Coaxial ControlNet Option Module - Manual (Page 16)

16 Rockwell Automation Publication 750COM-UM003B-EN-P - November 2012
Chapter 1 Getting Started
Quick Start This section is provided to help experienced users quickly start using the option
module. If you are unsure how to complete a step, refer to the referenced chapter.
Step Action See
1 Review the safety precautions for the option module. Throughout this manual
2 Verify that the PowerFlex drive is properly installed. PowerFlex 750-Series AC Drive
Installation Instructions,
publication
750-IN001
3 Install the option module.
a. Verify that the PowerFlex drive is not powered.
b. Insert the option module in drive Port 4, 5, or 6.
c. Use the captive crews to secure and ground the option module to
the drive.
d. Connect the option module to the network with a ControlNet
cable.
Network Communication Option
Module Installation Instructions,
publication
750COM-IN002 and
Chapter 2 ,
Installing the Option Module
4 Apply power to the option module.
a. Verify that the option module is installed correctly.
The option module receives power from the drive.
b. Apply power to the drive.
The status indicators should be green. If they flash red, there is a
problem. See
Chapter 7 , Troubleshooting.
c. Configure and verify key drive parameters.
Chapter 2 ,
Installing the Option Module
5 Configure the option module for your application.
Set option module parameters for the following functions as required by
your application:
• Node address
• I/O configuration
• Master-Slave hierarchy
• Fault actions
Chapter 3 ,
Configuring the Option Module
6 Configure the controller to communicate with the option module.
Use the network configuration tool RSNetWorx for ControlNet software,
and a controller configuration tool, such as RSLogix software, to configure
the master on the network to recognize the option module and drive.
Chapter 4 ,
Configuring the I/O
7 Create a ladder logic program.
Use a controller configuration tool, such as RSLogix software, to create a
ladder logic program that enables you to do the following:
• Control the connected drive, via the option module, by using I/O.
• Monitor or configure the drive by using explicit messages.
Chapter 5 ,
Using the I/O
Chapter 6 ,
Using Explicit Messaging