Rockwell Automation 442L SC300 Safety Sensor User Manual - Manual (Page 25)

Rockwell Automation Publication 10000202762 Ver 00 - January 2012 23
Chapter 4 Mounting
Note You will find other mounting options on the example application at
www.rockwellautomation.com .
Mounting on a frame
Notes
Always mount the camera with at least two screws and use the fastening openings on two
opposite sides of the housing.
Secure the two mounting screws against unintentional loosening.
Always use washers under the screws (Figure 13)
To mount the camera use sliding nuts suitable for the profile system used or the clamping
lugs available as accessories (see “Accessories” section on page 53).
Pay attention to the thickness of the flange on the camera when selecting a suitable screw
length (see “Dimensional drawings” section on page 50).
Figure 13 - Example: mounting with sliding nuts on different thickness profiles
Figure 14 - Example: mounting with clamping lugs on different thickness profiles
Align the camera such that the housing markings are aligned with the inside of the frame
profile. (The protective field stretches between the housing markings and the ends of the
reflective tape.)
Housing markings Housing markings
Mounting on 60 mm profile Mounting on 40 mm profile
SC300
R R
SC300
Housing markings Housing markings
Mounting on 50 mm profile Mounting on 30 mm profile
SC300
R R
SC300